Spare parts are available through your local distributer

This differs dependent on the unit. Please refer to the user manual

For optimum energy efficiency and not including our range of fully built in Integral units which are designed to be fully built in, we recommend our units are positioned in a place with ventilation around the unit, away from direct sunlight and not directly under air conditioning. Further details can be found in the user manual

All Husky units have replaceable pull out /push in door gaskets without the use of an engineer

All Husky products use compressor technology, therefore there is an amount of noise associated with our products. This fluctuates dependent upon the model and whether the intended use of the unit is for domestic or commercial use. All products are professionally db rated and results available upon request. We also supply a range of “homebars” where units have been specifically designed to keep noise down to a minimum.

Yes, In some models the condensor is positioned inside the unit frame hence these areas are warm (not hot) to the touch.

Most models the door hinge can be changed. In some instances where the units have heated doors (Alfresco) this is not the case. Revert to your user manual for more details

Yes, dependent on the model. In some models the evaporator plate is situated at the back of the unit which in times of high temperatures and humidity may show signs of dripping. This dripping water is collected in a tray at the bottom of the unit and through self evaporation clears the water without any action being needed by the customer

No. Your Husky fridge comes with a built in thermostat controller which will control the temperature when the unit is not in use. There is an independent light switch in most units you can turn off at night which does not affect the running of the unit

All Husky units come with either an electronic thermostat controller (commercial units) or manual thermostat controller (domestic products). Follow instructions in your user manual to change the temperature to your own requirements